Galaxy Note II (GT-N7100) GT-N7100 INS (Kitkat) Download File



               Galaxy Note II (GT-N7100) GT-N7100 INS (Kitkat)  




Download  File =   GT-N7100 INS (Kitkat                 





Flash Samsung Stock ROM (Official/Original Firmware) via Odin
Step 1: Download and install device driver software on your computer.

If you have used Kingo android Root already, skip this step. Otherwise, do it manually. Following are ways to do this...
Visit Samsung official website to find the correspondent driver software.
Google the driver software of your device. Download and then install it on you computer.
Download or update Kies, part of which will install or update drivers.

Once drivers are installed or updated, it is highly recommended that you restart your computer.


Originality has its place.
Amara. Love the new, the unique and the different, but for deliveries, they prefer the tried and tested.





Step : Download and extract the Stock ROM (Official/Original Firmware).

Boot your Samsung device into Download mode.

Follow these steps to enter Download Mode/Odin Mode
Power off your device
Press and hold Volume Down key, Home Key and Power Key
When your device vibrates, release Power key while keep holding the Volume Down key and Homekey

Warning before entering into download mode
Press Volume Up key to enter Download mode, which has a green robot figure and “Downloading… Do not turn off target!!)

Now you are in download mode.
Step 5: Connect your device to PC.

You device should be automatically recognized by Odin. At the lower-left of Odin interface, it should show a message that says "Added!" and in the meantime you should see a light-blue box at the ID:COM section stating "COM:3" (the number depend on which USB port you have plugged the device cable and is irrelevant).



Device is connected to Odin.
Step 6: Click "PDA" or "AP" to add tar.md5 file that you have extracted and then "Start".

Whether it is "PDA" or "AP" depends on the version of Odin that you used. But the md5 file goes to either "PDA" or "AP".



Add *.md5 to Odin.

After adding the file, click "Start" to begin the flashing process.



Click "Start" to flash.

WARNING DO NOT REMOVE OR OPERATE ON YOUR DEVICE UNTIL FINISHED OR FAILED IS SHOWED ON ODIN.



Ongoing flashing process. Do not remove your device.

When the flashing process is done and if everything goes well, you should see a big green box saying "RESET" or "PASSED" (depends on the version of Odin is used). By now, the device should be rebooted and it is safe to remove/unplug your device.



Flash succeeded.

No comments:

Powered by Blogger.